Aluminium Radiator Advantages And Installation
Aluminum radiator, also known as radiator aluminum or solar flower aluminum, aluminum radiator has a beautiful appearance, light weight, good heat dissipation, energy saving and so on. Guiyang Ou Kard Industrial Automation Technology Co., Ltd. With long-term accumulation of technical experience and production technology, set aluminum alloy profiles with good thermal conductivity and other characteristics, developed to meet customer differentiation of products, specialization and personalized requirements Customized aluminum radiator. The machined aluminum radiator surface is subjected to anodic oxidation for surface treatment to increase the corrosion resistance, abrasion resistance and appearance of the aluminum. At present, the commonly used radiator aluminum types are: electronics, electrical appliances, computer radiator aluminum, solar flower aluminum radiator, power semiconductor radiator profiles. Aluminum radiator because of its superior performance is widely used: machinery, automobiles, wind power, engineering machinery, air compressor, railway locomotives, household appliances and other industries.
Aluminum radiator mainly high-pressure cast aluminum and tensile aluminum alloy welding two.
① aluminum radiator heat dissipation is better, the characteristics of energy-saving is very obvious, in the same room, if the same specifications of the radiator, the number of aluminum cast less than steel
② aluminum radiator corrosion resistance and good performance, without adding any additives, the principle is that once the aluminum in the air encountered oxygen, then the letter generated a layer of oxide film, this film is both tough and dense, to prevent further on the body material Of corrosion.
Choose aluminum radiator, the best choice for high-pressure cast aluminum module combination radiator. This radiator is an integral die-cast, so no weld leakage. And its biggest advantage is that the product is not subject to residential heating system restrictions, even in the open boiler system can not be subject to oxygen corrosion due to the use of modular modular design, after a heating season, if the indoor temperature is not enough, but also Can be installed in the second year, one or two to meet their own needs, rather than the need for steel radiators need to replace the whole group of heating.
In addition, because the aluminum radiator on the water quality requirements and steel is not the same, so should avoid the aluminum radiator and other materials mixed installation.
Aluminum radiator installation steps
First of all, please open the aluminum radiator package, first put the valve, live joints.
2. The location of the holes for the installation of the hooks can be drawn on the wall according to the supplied installation drawings or related requirements.
3. Install the aluminum radiator to consider the heating tube heat shrinkage to the radiator to bring the damage.
4. Put the 12 expansion tube into the flat.
5. Please use the impact drill drill hole 12, the depth of the expansion tube into the outside, the outside and the wall is flush is appropriate.
6. Install the bottom hook to meet the requirements after tightening the screws.
7. Place the aluminum heatsink on the bottom of the installed hook, install the top hook to adjust the hook position, to be tightened before the expansion of the screw, place the radiator, put the valve on the top.
8. Install the assembly pipe fittings, and then press the drawings to install the pipeline and connected with the inlet and outlet, fastening, the rear side of the wall 3.5cm, from the kick angle 5cm.
9. Please enter the hot water, open the release valve, deflate until the water. Aluminum radiator operation shall not exceed the working pressure listed in the manual 0.12Mpa.
10. Oxygen in the heat medium shall not exceed 0.05 g per square meter. Radiation of the media used in the water should be PH9 ≤ 9, with anti-corrosion measures PH ≤ 12.